Wet Pour

Playscape Wet Pour is suitable for all installations where safety surfacing is a requirement, up to the appropriate Maximum Free Fall Height (see chart below). It can be used around complex configurations of playground equipment and ground contours.

Playscape Wet Pour is slip-resistant and non-abrasive to young limbs. It is porous, so puddles, which can create slippery conditions in the winter, do not form.

Graphics for Playscape Wet Pour can be as colourful and unlimited as your imagination.Click here for examples.

Playscape Wet Pour - Fall Height Chart
	20mm	30mm	40mm	50mm	60mm	70mm
Playscape Wet Pour Thickness
	80mm	90mm	100mm	110mm	120mm	130mm
Playscape Wet Pour Thickness

Add to the play value of your playscape with graphics and games designed into the wet pour which will complement individual themes.

Bases
Our Playscape Wet Pour system is designed to be laid onto the following bases -

• Up to 12mm stone no-fines concrete or open-textured bitmac
• MOT Type 1 stone (surfaces with a thickness of 50mm or more)
• Existing tarmac or concrete, subject to being in good condition
• Other existing surfaces/bases, subject to preparation in accordance with Wicksteed’s specific recommendations

Material
Playscape Wet Pour is bonded rubber, mixed on site using special equipment and laid to exacting standards. The base layer is SBR (Styrene Butadiene Rubber). The top layer is recycled EPDM (Ethylene Propylene Di Monomer), unless virgin rubber is requested.

Colours and Graphics
Playscape Wet Pour is available in the colours shown here Click here for a colour chart..

Maintenance
In the event of localised, accidental damage or vandalism, a Repair Kit is available.